Last Updated on March 16, 2022
You bought a new Amana refrigerator and now it won’t cool.
What should you do?
Amana has been around since the 1950s and was once the top selling brand in America.
The company has also had its share of problems over the years.
In 2014, they recalled thousands of refrigerators after reports of water leaking into the unit.
First, check the temperature settings on the thermostat.
If the temperature is too high or low, adjust them accordingly.
Next, check the drain pan under the fridge.
Make sure it drains properly.
If it does not, call Amana customer service at 800-827-4227.
They’ll be able to assist you
Amana Refrigerator Compressor Running But Not Cooling – How to Solve It
This problem occurs when the compressor runs but the cooling system does not function properly. This could happen if the refrigerant level is low. To check the refrigerant level, open the door of the refrigerator and remove the cap from the top of the evaporator coil. Check the level of refrigerant in the uppermost tube. If the level is low, replace the cap and wait for the unit to cool down. If the refrigerant level is normal, replace the cap and run the compressor.
i. Clean the Condenser Coils
Clean the condenser coils using a dry cloth. Use a clean towel to wipe off any dust particles or debris. ii. Replace the Cap Answer: Remove the old cap and install the new cap. Make sure the gasket is installed correctly. Tighten the screws until the gasket is fully seated.
ii. Troubleshoot the Motors
Check if the motors are working properly. Turn the knob clockwise to check if the motor turns smoothly. If not, replace the switch board. iii. Inspect the Heat Exchanger Answer: Check the heat exchanger for cracks or damage. If found damaged, replace it immediately.
iii. Ensure the Start Relay and Capacitor are Working Properly
Check the start relay and capacitor for any short circuit. Replace if found defective. iv. Check the Thermostat Answer: Check the thermostat for proper operation. If the thermostat is faulty, replace it.
iv. Ensure There is No Coolant Leakage
Check the coolant level. If the coolant level is low, fill the reservoir with coolant. v. Check the Drain Valve Answer: Check the drain valve for proper operation. If it does not open properly, check the drain hose for blockages.
v. Troubleshoot the Thermistor
If the thermistor is defective, the unit will not function properly. Replace the thermistor if necessary. vi. Clean the Filter Answer: Remove the filter from the unit and clean it thoroughly.
Amana Refrigerator and Freezer Not Cooling — Solutions
1 Check the thermostat if present. It could be stuck open or closed. 2 Make sure the fan switch is set to “on”.
i. Ensure That the Condenser Coils are Clean
If the condenser coils are dirty, they won’t cool properly. To clean the condenser coils, turn off the power supply to the refrigerator. Remove the front panel from the refrigerator. Unplug the refrigerator and remove the two screws holding the top plate in place. Lift the top plate away from the refrigerator. Pull the condenser coil assembly out of the back of the refrigerator. Disconnect the wires connected to the condenser coil. Use a wire brush to clean the condenser coils. After cleaning, reattach the condenser coil assembly to the back of the refrigerator and replace the top plate. Plug the refrigerator back into the electrical outlet. Turn the power supply back on.
ii. Examine the Evaporator Fan Motor
To check if the evaporator fan motor is working correctly, open the door of the refrigerator and listen for the sound of the fan running. If the fan does not run, check the wiring connections between the fan motor and the compressor. If the fan still doesn’t run after checking these connections, replace the fan motor. iii. Check the Refrigerant Level Answer: To check the refrigerant level, open the door of refrigerator and pull the ice maker tray out. Look for any leaks around the drain hole. If you see any leak, add more refrigerant to the system. Replace the ice maker tray. Close the door of the refrigerator. Wait 10 minutes. Open the door again. Listen for the sound of the compressor running. If the compressor does not start, check the wiring connections. If the compressor starts but the fan does not run when the door is closed, replace the fan motor and the relay.
iii. Ensure that the Defrost Heater is Working Properly
Open the door of the refrigerator, remove the freezer drawer, and check the defrost heater. If the defrost heater is not working properly, replace the defrost heater. iv. Check the Thermostat Answer: To check whether the thermostat is working properly, turn off the power switch and wait 30 seconds. Then, press the power button of the thermostat. If the display explains “0°F”, replace the thermostat.
iv. Examine the Temperature Control Thermostat
To examine the temperature control thermostat, open the door of the refrigerator and remove the temperature control thermostats. Replace the temperature control thermostatic if the display explains 0°F. v. Check the Power Supply Answer: To check the power supply, turn off the power supply switch. Open the door of the refrigerator. If the light is blinking, replace the power supply.
v. Troubleshoot the Start Relay
Open the door of the refrigerator, remove the start relay, and replace the start relay if the display explains 0°F. vi. Examine the Door Lock To examine the door lock, open the door of refrigerator and remove the door lock. Replace the door lock if the display explains 0 degrees Fahrenheit.
Amana Refrigerator Not Cooling Enough – What to Do
1. Check the thermostat setting. Make sure the thermostat setting is set to “cool”. 2. Check the power cord connection. Make sure the power cord is connected properly.
Check out these other articles on refrigerators not cooling for other brands…
Amana Refrigerator Not Cold enough – What to Do If your refrigerator is not keeping cold air inside, check the following: 1. Is the door closed tightly?
Amana Refrigerator Not Cooling But Freezer Is Working — How to Fix
2. Are the shelves level? 3. Did you clean the coils?
i. Check the Damper Control Assembly
If the freezer is not cooling properly, check the damper assembly. It is located near the evaporator coil. Remove the screws from the top panel and remove the panel. Look for any debris or dust buildup. Clean the coils using compressed air. Replace the panel and reattach the screws. 4. Check the Thermostat 5. Check the Door Seal
ii. Check the Defrost Control Board
1. Check the Damper Assembly 2. Check the Thermostatic Switch 3. Check the Defrost Time 4. Check the Defrost Controller 5. Check the Defrost Motor 6. Check the Door Seal
iii. Check If the Evaporator Fan Motor is Working
ii. Check the Defrost Controls 1. Check the damper assembly 2. check the thermostatic switch
How do I reset my Amana refrigerator?
Yes, there is a reset button on every single refrigerator. It is located on the back side of the refrigerator door. This button is used to turn off the power supply to the refrigerator. In case if the refrigerator does not shut down properly, press this button to restart the power supply.
How do you hard reset a refrigerator?
A refrigerator is a vital part of any household. It keeps our food cold and fresh. A fridge is very important because we eat a lot of food every day. We buy groceries, fruits, vegetables, meat, fish, breads, eggs, milk, cheese, butter, juices, drinks, and other items from supermarkets. These items are stored in the refrigerator. So if the refrigerator stops working, then we cannot store these items properly. To fix the problem, you need to follow the steps below. Step 1: First, turn off the power supply to the refrigerator. Then remove the plug from the wall outlet. Step 2: Remove the back panel of the refrigerator. Step 3: Find the circuit board located under the freezer. This is where the compressor is connected. Disconnect the wires from the circuit board. Step 4: Unplug the wire connector from the circuit board. Now disconnect the wires from the compressor. Step 5: Replace the back panel of the fridge. Plug the wires into the new circuit board. Turn on the power supply to the fridge.
If you have a problem with your Amana refrigerator, you can contact the manufacturer directly for help. To reset the clock on your Amana refrigerator, follow these steps: 1 Press and hold the power button until the light turns off 2 Remove the battery from the back of the unit 3 Place the battery into the charger 4 Wait for the indicator to turn green 5 Replace the battery 6 Turn the power button on 7 Press and hold the reset button 8 After approximately 30 seconds, release the reset button 9 Press and hold the start/stop button 10 Release the start/stop button 11 Press and hold the door lock button 12 Release the door lock button 13 Press and hold the ice maker button 14 Release the ice maker button 15 Press and hold the freezer button 16 Release the freezer button 17 Press and hold the defrost button 18 Release the defrost button 19
It's knowing what you're doing and having a good basic foundation.
That's why my mission is to teach you the fundamentals of great cooking...
So you can start creating delicious dishes without any rules or restrictions whatsoever.
With my step-by-step instructions, my unique insider secrets and techniques,
You'll be able to easily take ordinary food and make it extraordinary!
- How Long does Yogurt Take to Freeze - May 5, 2023
- Top 10 best restaurants in Montana - May 1, 2023
- 3 Ingredient Lemon Pie - March 27, 2022